TDS 3000 Series

---

Digital Phosphor Oscilloscope : TDS 3000 Series

---

TDS 3002B 시리즈(2CH) : 모델 TDS 3012B(100MHz), TDS 3032B(300MHz), TDS 3052B(500MHz) TDS 3004B 시리즈(4CH) : 모델 TDS 3014B(100MHz), TDS 3034B(300MHz), TDS 3054B(500MHz)

▷ 특 징 (Features)
TDS3BAT (NiCd Battery pack) Application module being installed	500 MHz, 300 MHz and 100 MHz Bandwidths Sample Rates up to 5 GS/s 2 or 4 Channels Full VGA Color LCD 25 Automatic Measurements 9-Bit Vertical Resolution Multi-language User Interface QuickMenu Graphical User Interface for Easy Operation Built-in Ethernet Port e*Scope Web-based Remote Control WaveAlert Automatic Waveform Anomaly Detection Application Modules Advanced Analysis Module for Detailed Design Analysis Telecommunications Mask Testing FFT Two Video Modules for Testing and Troubleshooting Limit Testing for Rapid Go/No-Go Testing Advanced Triggers including Glitch, Runt and Logic Plug-in Printer for Portable Documentation of Results TekProbeTM Level II Interface Supports Active, Differential and Current Probes for Automatic Scaling and Units Centronics Port Standard on all Models for Quick, Convenient Hardcopies Built-in Floppy Disk Drive For Easy Storage and Documentation
▷ 응 용 (Applications)
Telecommunications Manufacturing Test Digital Design and Debug Video Installation and Service Power Supply Design

▷ TDS3000B Series Specifications
모 델	TDS3012B	TDS3014B	TDS3032B	TDS3034B	TDS3052B	TDS3054B
Bandwidth	100 MHz	100 MHz	300 MHz	300 MHz	500 MHz	500 MHz
Channels	2	4	2	4	2	4
Sample rate on each channel	1.25 GS/s	1.25 GS/s	2.5 GS/s	2.5 GS/s	5 GS/s	5 GS/s
Maximum record length	10 K points on all models
Vertical resolution	9 Bits on all models
Vertical sensitivity (/div)	1 mV - 10 V on all models
Vertical accuracy	±2% on all models*1
Max input voltage (1 megaohm)	150 VRMS CAT I on all models (300 V CAT II with standard 10X probe)
Position range	± 5 div on all models
BW limit	20 MHz	20 MHz	20, 150 MHz	20, 150 MHz	20, 150 MHz	20, 150 MHz
Input coupling	AC, DC, GND on all models
Input impedance selections	1 megaohm in parallel with 13 pF or 50 Ohm
Time base Range	4 ns - 10 s/div	4 ns - 10 s/div	2 ns - 10 s/div	2 ns - 10 s/div	1 ns - 10 s/div	1 ns - 10 s/div
Accuracy	20 ppm	20 ppm	20 ppm	20 ppm	20 ppm	20 ppm
Display monitor	Color LCD
Trigger System	Main Trigger Modes - Auto (supports Roll Mode for 40 ms/div and slower), Normal. B Trigger - Trigger after time or events. Trigger After Time Range - 13.2 ns to 50 s. Trigger After Events Range - 1 to 9,999,999 events. External Trigger Input - >1 megaohm in parallel with 17 pF; Max input voltage is 150 Vrms.
Trigger Types	Edge - Conventional level-driven trigger. Positive or negative slope on any channel. Coupling selections: DC, noise reject, HF reject, LF reject. Video - Trigger on all lines, odd/even or all fields. With TDS3VID or TDS3SDI trigger on individual lines and on analog HDTV formats (1080i, 1080p, 720p, 480p). Logic (requires TDS3TRG) - PATTERN: Specifies AND, OR, NAND, NOR when true or false for a specific time. STATE: Any logic state. Triggerable on rising or falling edge of a clock. Logic triggers can be used on combinations of 2 inputs (not 4). Pulse (requires TDS3TRG) - WIDTH (or GLITCH): Trigger on pulse width less than, greater than, equal to or not equal to a selectable time limit ranging from 39.6 ns to 50 s. RUNT: Trigger on a pulse that crosses one threshold but fails to cross a second threshold before crossing the first again. SLEW RATE: Trigger on pulse edge rates that are either faster or slower than a set rate. Edges can be rising, falling or either. Comm (requires TDS3TMT) - Provides isolated pulse triggering required to perform DS1/DS3 telecommunications mask testing per ANSI T1.102 standard. Alternate - Sequentially uses each active channel as a trigger source.
Measurement System	Automatic Waveform Measurements - Period, Frequency, +Width, -Width, Rise Time, Fall Time, +Duty Cycle, -Duty Cycle, +Overshoot, -Overshoot, High, Low, Max, Min, P-P, Amplitude, Mean, Cycle Mean, RMS, Cycle RMS, Burst Width, Delay, Phase, Area*1, Cycle Area*1. Display any four measurements from any combination of waveforms. Or display all measurements with measurement snapshot feature. *1 Requires TDS3AAM module. Thresholds - Settable in percentage or voltage. Gating - Measurements can be gated using the screen or vertical cursors.
I/O Interface	Hard Copy Port (standard) - Centronics-type parallel.
Dimensions	375.0mm(W) X 176.0mm(H) X 149.0mm(D)
Weight	3.2kg(Instrument only), 5.2kg(with battery)
*1 Derated at 0.025%/°C for temperatures above +30°C and below +18°C.

▷ TDS3GV Communications Module (Options)
GPIB Port	programmability(IEEE -488.2), Full talk/listen modes; Control of all modes, settings and measurements.
VGA Port	Monitor output for direct display on large VGA-equipped monitors. DB-15 female connector, 31.6 kHz sync rate, EIA RS-343A compliant.
RS-232 Port	interface programmability: Full talk/listen modes; Control of all modes, settings and measurements. Baud Rate up to 38,400. DB-9 male connector.
071-0381-01	Programmer manual

▷ 선택사양(Options)
TDS3PRT
TDS3TMT	Telecom mask testing application module.
TDS3AAM	Advanced analysis module.
TDS3LIM	Limit test module.
TDS3FFT	Fast fourier transform module.
TDS3TRG	Advanced trigger application module.
TDS3VID	Extended video application module.
TDS3SDI	601 serial digital video module.
TDS3GV	GPIB, VGA and RS-232 interfaces.
TDS3BAT	NiCd Battery pack for up to 2 hours continuous operation without line power. Note: The instrument must be grounded at all times.
TDS3PRT	The TDS3PRT plug-in printer adds easy, portable documentation capability to your TDS3000B or TDS3000 oscilloscope. Just plug it into the back of your oscilloscope and press Hard Copy to get a print of your screen. The printer works where your TDS3000B works - even when operating on battery power.
Note: With TDS3000, printer does not operate on battery power.
016-1907-00	5-roll pack of paper for TDS3PRT plug-in thermal printer.
TDS3CHG	Fast charger for battery pack.
AC3000	Soft case for carrying instrument.
HCTDS32	Hard plastic case for carrying instrument.
RM3000	RM3000 - Rackmount kit.
071-0972-00	Service Manual (TDS3000B Series) - English only
071-0381-01	TDS3GV Programmers Manual - English only
WaveStarTM	Software for Oscilloscopes - Microsoft Windows 95/98/NT 4.0 Application.
VocalLinkTM	Voice Control Software

▷ 선택사양-프루브(Options-Probes)
ADA400A	100X, 10X, 1X, 0.1X high gain differential amplifier.
P6243	1 GHz, <1 pF input C 10x active probe.
P5205	1.3 kV, 100 MHz high voltage differential probe.
P5210	5.6 kV, 50 MHz high voltage differential probe.
P5100	2.5 kV, 100X high voltage passive probe.
TCP202	15 A, DC + peak AC 50 MHz AC/DC current probe.

◈ 카탈로그 사양 보기

▷ Model TDS3012B/TDS3014B/TDS3032B/TDS3034B/TDS3052B/TDS3054B Download Datasheet(PDF file-영문판) ▷ Model TDS3012B/TDS3014B/TDS3032B/TDS3034B/TDS3052B/TDS3054B Download Datasheet(PDF file-한글판)

** 이 파일은 pdf파일이므로 Acorbat Reader 프로그램을 설치하신 후 보실수 있습니다. **◆ 다운로드(Download) 방법 : 마우스의 오른쪽 키를 누른 후 "다른 이름으로 대상 저장(A).."을 선택한 다음 저장하신 후 보시면 편리합니다